[mau_ven]

0

Dear all , good morning !

DECODER: SUNRAY 800 HD SE SR4
CLONE
SIM A8P
IMAGE: Nemesis 2.6 110r0
ERROR-:NO CA FOUND
story .... (the decoder does not recognize internal HD) and I wanted to try a new image

I tried to reset the decoder with Optiflasher pro with the appropriate option, but when restart the decoder ( program asks me the IP address std 192.168.1.77) decoder in stop mode; but no possible to update image from bronswer , after a few seconds start boot of the 'image nemesis" and starts and is running correctly . turning it off to reboot .I still have again with NO CA FOUND error.

some suggestions ?

thanks a lot

Regards

[mau_ven]

0

Dear Friend,

I replaced the Sim card A8P but the problem remains, I think the problem is on the transfer, (IP address 192.168.1.100 PC) the decoder syand-by in stop mode, and displays the decoder shows 192.168.1.77, the ethernet connection is up and running ok but the decoder does not respond to ping (see attached image)

and can do a reset HW / SW decoder? or do you have any suggestions?

thanks a lot

Regards

[mau_ven]

0

Dear Friend,

I replaced the Sim card A8P but the problem remains, I think the problem is on the transfer, (IP address 192.168.1.100 PC) the decoder syand-by in stop mode, and displays the decoder shows 192.168.1.77, the ethernet connection is up and running ok but the decoder does not respond to ping (see attached image)

and can do a reset HW / SW decoder? or do you have any suggestions?

thanks a lot

Regards

---

Hello ,

I can not upload the firmware, checked SIM A8P

I tried to connect Terminal from serial ... this is message:
 
someone can give me help?



COPY CODE
COMPARE CODE
4567
© 2007,2008 Dream Multimedia GmbH. All rights reserved.
Dreambox DM800SE

FIRST STAGE 1.0/400 {BO23456}

2ND STAGE OK, build #84 (2011-09-01)

0.000 - BCM board setup
0.000 - fp init
0.000 - ca init
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
CA invalid
OLED found!
color oled reset
NO CONFIGURATION DATA PRESENT. STOP.
lcd: * ERR01: NO CA FOUND
0.532 oled: string too long: '* ERR01: NO CA FOUND'

thanks