[baber]

0

dear friend
Hi

yesterday i bought new dm900 4k i did not flash any image on that i turn off that and now when want power on from back just show red light in front of panel and can not go in rescue mode just can connect with serviced console with com3 and i buy your software optiflasher pro dmips edition 3.0.2.3

but nothing do any

this is my log

CPU 01
Dreambox DM900
AVS init...
AVS init OK
AVS load:select_image: addr_offset: 00051000 part_offset: 00000000 bootStatus: 2a002b00
AVS load_code offset =00051000
LOADED
AVS: overtemp mon ON

single board
select_image: addr_offset: 00055000 part_offset: 00000000 bootStatus: 3d2b2500
MEMSYS-STD
SHMOO 02010000 BLD:11138M HW:hpf0_b1p6 V:2.1.0.0
MCB: FLEX
AVS start:status=000000ff
STB: Current voltage=0000037a(890)
temperature=0000d31b(54043)
PV=0000033e(830)
MV=0000037b(891)
AVS FW rev=30333278 [0.3.2.x]
OK
DDR0: !@ ffe0e780 <= ffe0df10 MEMSYS-0 @ f1100000
MEMSYS ERROR: 00000001

eMEMC:
00000000
ePHY: 00000000
eSHMOO: 12400000 00000082 00000000
CPU 01
Dreambox DM900
AVS init...
AVS init OK
AVS load:select_image: addr_offset: 00051000 part_offset: 00000000 bootStatus: 2a2f2b00
AVS load_code offset =00051000
LOADED
AVS: overtemp mon ON

single board
MEMSYS:0000002f
FATAL ERROR: Boot 2nd image failed

when press on do job just show attached pic and nothing do after 30 min