01-27-2012, 01:00 PM
0
1-Standard Mode : By Pressing Power button & Keep Pressing Until See STOP MODE IP:xxxxx
this mode need Only Lan 45 cable if can access Stop mode without problems .
For this mode, it's not possible because i cannot see the IP (the device display stay blank)
2-Switch to Stop Mode : From Tv mode OptiFlasher will switch with warning message (use this option if you have a fixed ip) on Tv mode + "Manual IP fixed not DHCP active from Terminal Setup" !
this mode need Only Lan RG45 cable if can access Stop mode without problems .
Not possible too
3-Use RS232/USB & Lan Mode : This mode used in case of boot error or No ca Found problem
Not operative, the flash software is waiting the device power on even if i already switch on the device
4-Use RS232/USB Mode Only : This mode used in case of boot error or No ca Found problem
Not operative, the flash software is waiting the device power on even if i already switch on the device
[/quote]
this mode need Only Lan 45 cable if can access Stop mode without problems .
For this mode, it's not possible because i cannot see the IP (the device display stay blank)
2-Switch to Stop Mode : From Tv mode OptiFlasher will switch with warning message (use this option if you have a fixed ip) on Tv mode + "Manual IP fixed not DHCP active from Terminal Setup" !
this mode need Only Lan RG45 cable if can access Stop mode without problems .
Not possible too
3-Use RS232/USB & Lan Mode : This mode used in case of boot error or No ca Found problem
Not operative, the flash software is waiting the device power on even if i already switch on the device
4-Use RS232/USB Mode Only : This mode used in case of boot error or No ca Found problem
Not operative, the flash software is waiting the device power on even if i already switch on the device
[/quote]