Hello guest, if you read this it means you are not registered. Click here to register in a few simple steps, you will enjoy all features of our Forum.
This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
  • ¡Welcome to InfoServ!
Hello There, Guest! Login Register


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Title: A solution when can't finish upgrading
Thread Modes
#1
0
when you upgrading but can't finish it


you can try this as follow
1.connect receiver to pc with ethernet port.
2.press standby button then power-on.
3.open DCC and make a telnet with receiver.
4.in Misc --Flash Sector Recovery, change DISABLED to ENABLED

5.then save it

6.now open your browser and try upgrading again.
gook luck.
 
Reply
  


Forum Jump:


Browsing: 2 Guest(s)