[brianmullen8]

0

X is the magic key. It bypasses no can error and boots box. Will try to flash tomorrow.

[brianmullen8]

0

Hi, I have the box booted using the x key it says dvi then scart on the display but it won't display on the TV. I went into the box bios and restored factory settings. I was hoping i could boot the box then flash through usb stick. I tried to use the remote to select scart or dvi but the remote won't do anything.

Could all this be a hardware issue or can the wrong bootloader cause all these problems. I have asked a mate if I can borrow his dm800. Can I flash ssl84d onto the sim using his box then put it back in mine?

Thanks

[fairbird]

0

Actually, No >>>
sim card only as like Security Gate just recognize the sim and accept SSlxx to upload to box ..to internal flash

[brianmullen8]

0

Thanks fairbird, I will try to flash it using dream up with the good box connected then connect the bad one.

[brianmullen8]

0

Hi,

I have the second dm800 now.

I connected dream-up and it found the box good box 1st time i then put the null modem cable into the broken box and it uploaded the flash loader i pressed flash and selected bl76 but it got no further than acknowledge sent

i have tried a second time now and it as taking a long time to upload the flash loader, hopefully it is uploading correctly now.

Just a quick question

When do i swap the null modem cable over?

1. as soon as the box is detected before flash loader starts to upload
2. as soon as flash loader starts to upload

Thanks

[fairbird]

0

as soon as the box is detected before flash loader starts to upload

[brianmullen8]

0

thanks for the quick reply fairbird

It has been on waiting for acknowledge now for over 30mins is that right?

[fairbird]

0

No should be directly connecting with pc and start flash image (If progress for flashing start then you need around one hour to finish flash image)

[brianmullen8]

0

still getting nowhere. When the flash uploader starts to go over the box goes into serial mode then it starts booting.

Can i remove the flash chip from one box onto the other to flash it (i have a rework station)

[fairbird]

0

Certainly You can not remove flash chip from motherboard ...

You JUST have problem on connection..So try every things as I mentioned to you before again and again or take the box to technical to make test on port com working or not ...