04-13-2014, 02:47 PM
0
Here is a print out at 38400 baud rate, The first one is a sim 2.10 the second is a sim 2. I was going to buy another sim but i still wont be able to flash. i think the baudrate has been set to 38400 at some point by someone. can i reset the bios on dm800?
© 2007,2008 Dream Multimedia GmbH. All rights reserved.
Dreambox DM800
FIRST STAGE 1.00 {BO23456}
2ND STAGE OK, build #76 (20100419)
0.000 - BCM board setup
{00000126,00000126,00000125,00000124,00000123,00000133}
0.007 - fp init
0.008 - ca init
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
CA invalid
OLED found!
NO CONFIGURATION DATA PRESENT. STOP.
* ERR01: NO CA FOUND
© 2007,2008 Dream Multimedia GmbH. All rights reserved.
Dreambox DM800
FIRST STAGE 1.00 {BO23456}
2ND STAGE OK, build #76 (20100419)
0.000 - BCM board setup
{00000126,00000126,00000125,00000124,00000123,00000133}
0.007 - fp init
0.008 - ca init
CA invalid
OLED found!
NO CONFIGURATION DATA PRESENT. STOP.
* ERR01: NO CA FOUND
© 2007,2008 Dream Multimedia GmbH. All rights reserved.
Dreambox DM800
FIRST STAGE 1.00 {BO23456}
2ND STAGE OK, build #76 (20100419)
0.000 - BCM board setup
{00000126,00000126,00000125,00000124,00000123,00000133}
0.007 - fp init
0.008 - ca init
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
CA invalid
OLED found!
NO CONFIGURATION DATA PRESENT. STOP.
* ERR01: NO CA FOUND
© 2007,2008 Dream Multimedia GmbH. All rights reserved.
Dreambox DM800
FIRST STAGE 1.00 {BO23456}
2ND STAGE OK, build #76 (20100419)
0.000 - BCM board setup
{00000126,00000126,00000125,00000124,00000123,00000133}
0.007 - fp init
0.008 - ca init
CA invalid
OLED found!
NO CONFIGURATION DATA PRESENT. STOP.
* ERR01: NO CA FOUND