0
ah ok so the box is getting stuck on the boot logo, yes then the problem is with booting. Thanks for clarifying that :)
I also noticed after every 5 minutes the box does restart by itself.
I tried to follow your thread with the telnet but could not manage exactly, this is what I could do:
1. I did take the sim out and place back in firmly.
2. I make telnet to box (on STOP mode) and enabled FLASH SECTOR RECOVERY - I can do this only with either:
I. Lan cable on stop mode
II. null cable using dreamup ONLY on serial
I did not use optiflasher but these are my options when I use:
In Optiflasher I can do:
I. connect with LAN to flash and make telnet
II. flash image using NULL cable but NO telnet
Normally the ip address I get with LAN or dreamup is 192.168.0.15 or 192.168.0.21 (this works) BUT optiflasher gives ip address like 192.168.1.77 and to this I cannot make any telnet or webIF connection.
In the end I did the flash using WebIF because file is too big for dreamup. It did say in the webIF "bad sector recovery enabled" and the flash did work after a few minutes.
now I have boot logo for openPLI but same problem persists. box does auto restart every 5 minutes.
I am trying something a bit different - will telnet using LAN and change settings again to flash sector recovery but this time will save the settings so that when I turn off the box the setting does remain. Then I will use optiflasher via null cable and sector recovery to flash the image. now it is taking longer to flash the image maybe one hour like you said, lets see... ok no luck :( still same
I also noticed after every 5 minutes the box does restart by itself.
I tried to follow your thread with the telnet but could not manage exactly, this is what I could do:
1. I did take the sim out and place back in firmly.
2. I make telnet to box (on STOP mode) and enabled FLASH SECTOR RECOVERY - I can do this only with either:
I. Lan cable on stop mode
II. null cable using dreamup ONLY on serial
I did not use optiflasher but these are my options when I use:
In Optiflasher I can do:
I. connect with LAN to flash and make telnet
II. flash image using NULL cable but NO telnet
Normally the ip address I get with LAN or dreamup is 192.168.0.15 or 192.168.0.21 (this works) BUT optiflasher gives ip address like 192.168.1.77 and to this I cannot make any telnet or webIF connection.
In the end I did the flash using WebIF because file is too big for dreamup. It did say in the webIF "bad sector recovery enabled" and the flash did work after a few minutes.
now I have boot logo for openPLI but same problem persists. box does auto restart every 5 minutes.
I am trying something a bit different - will telnet using LAN and change settings again to flash sector recovery but this time will save the settings so that when I turn off the box the setting does remain. Then I will use optiflasher via null cable and sector recovery to flash the image. now it is taking longer to flash the image maybe one hour like you said, lets see... ok no luck :( still same
