Hello guest, if you read this it means you are not registered. Click here to register in a few simple steps, you will enjoy all features of our Forum.
The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 906 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 906 errorHandler->error



This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
  • ¡Welcome to InfoServ!
Hello There, Guest! Login Register

InfoServ > General > Off Topic Zone / General Discussion > [SOLVED] DM800 "partition 3 full or corrupt" error >

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Title: SOLVED DM800 "partition 3 full or corrupt" error
Thread Modes
dishboy Offline
Junior Member

**
Posts: 3
Threads: 1
Joined: Jul 2012
Reputation: 0
Thanks Given0
Thanks Received0
Thanks Meter 0%Thanks Meter
#1
07-08-2012, 09:30 AM (This post was last modified: 07-11-2012, 01:09 AM by fairbird.)
0
My clone box has been causing me some issues for a while now. I am unable load up an image to entirety, it fails on install about 1/3 way with an error of partition 3 corrupt or full.
I ran dreamup to repair the sectors and it did find a sector with a problem but the best I can do is upload and then it fails during flash install.
I tried to telnet but no OS to run telnet on box.

I am only able to connect to the box in http stop mode. Is there a rescue method to boot from USB or something else? This has nothing to do with second stage boot loader/no CA found. too much data (or bad sectors) in partition 3 (end: 04000000, pos: 04000000)
 
  
Thread closed


Messages In This Thread
DM800 "partition 3 full or corrupt" error - by dishboy - 07-08-2012, 09:30 AM

Forum Jump:


Browsing: 4 Guest(s)