[skyno]

0

I have an original DM920 UHD with a solid red light. When I connect the DM920 to the computer via Mini USB cable, Windows XP automatically detects it.
I open the software: OptiFlasher_DMipsV3.0.5.0_BETA5 and configure it in Recovery/rescue mode as shown in the video on youtube, link taken from the forum.
The problem is that the software detects the DM920 but does not proceed.
The software tells me:

Power ON DB Device [ESC to Abort]
Ballance Credits: 15
DM920UHD Detected !

Could you advise me how to interact with the DM and the software?
Maybe I'm doing something wrong?


P.S.

Putty detects the DM920.
The log is created:

CPU 01
Dreambox DM920
AVS init...
AVS init OK
AVS load:select_image: addr_offset: 00051000 part_offset: 00000000 bootStatus: 2a002b00
AVS load_code offset =00051000
LOADED
AVS: overtemp mon ON

single board
select_image: addr_offset: 00055000 part_offset: 00000000 bootStatus: 3d2b2500
MEMSYS-STD
SHMOO 02010000 BLD:11138M HW:hpf0_b1p6 V:2.1.0.0
MCB: FLEX
AVS start:status=000000ff
STB: Current voltage=000003b7(951)
temperature=00004df1(19953)
PV=0000036e(878)
MV=000003b7(951)
AVS FW rev=30333278 [0.3.2.x]
OK
DDR0: !@ ffe0e780 <= ffe0df10 MEMSYS-0 @ f1100000 OK
DDR1: =@ ffe0e780 <= ffe0df10 MEMSYS-1 @ f1180000
MEMSYS ERROR: 00000001

eMEMC:
00000000
ePHY: 00000000
eSHMOO: 10400000 00000082 00000000
CPU 01
Dreambox DM920
AVS init...
AVS init OK
AVS load:select_image: addr_offset: 00051000 part_offset: 00000000 bootStatus: 2a2f2b00
AVS load_code offset =00051000
LOADED
AVS: overtemp mon ON

single board
MEMSYS:0000002f
FATAL ERROR: Boot 2nd image failed