0
No one who knows and can help me with this problem.
When I use optiflasher I choose the advanced and LD2 and Repair ( no ca Found ) and then Do Job.
When the process is completed at optiflasher writes "Boot success Ready for Network web interface.
It also opens new window and there it says: Enter Ip shown ON *** STOP-Mode ***
But on the Dreambox is ERR1 NO CA Found.
What I'm doing wrong
If I use NCF repair SIM2 v3 then I get error message.
error
Can not Process Authorization Please Check:
-Network RJ45 Cable
-Network Domain 192.168.1.x
RJ45 cable is ok i have checked the
When I use optiflasher I choose the advanced and LD2 and Repair ( no ca Found ) and then Do Job.
When the process is completed at optiflasher writes "Boot success Ready for Network web interface.
It also opens new window and there it says: Enter Ip shown ON *** STOP-Mode ***
But on the Dreambox is ERR1 NO CA Found.
What I'm doing wrong
If I use NCF repair SIM2 v3 then I get error message.
error
Can not Process Authorization Please Check:
-Network RJ45 Cable
-Network Domain 192.168.1.x
RJ45 cable is ok i have checked the