01-15-2014, 07:39 PM
0
I become a little bit "nuts"
I use a stand alone PC (Windows 7 pro) with a crossover cable connected to the DM
(PC has a fixed IP 192.168.1.14 with 255.255.255.0 no Gateway and no dns)
Using optiflasher, after the boot load everything is OK (display gives 192.168.1.77) I can ping the DM and access the DM web interface, leds on both network cards are blinking intensiveky exchange of data is performed,....
Just putting power off then on (with crossover and serial cables present and in Stop mode) I am back to that display DHCP.
Any idea?
Thanks for your patience
I use a stand alone PC (Windows 7 pro) with a crossover cable connected to the DM
(PC has a fixed IP 192.168.1.14 with 255.255.255.0 no Gateway and no dns)
Using optiflasher, after the boot load everything is OK (display gives 192.168.1.77) I can ping the DM and access the DM web interface, leds on both network cards are blinking intensiveky exchange of data is performed,....
Just putting power off then on (with crossover and serial cables present and in Stop mode) I am back to that display DHCP.
Any idea?
Thanks for your patience