12-30-2013, 05:45 PM
0
Hello mate please have a look at the images below, a successful "no ca found repair". Please take note of the text in red rectangle.
I have observed that it is different from the message I get from the NCF tool when I do the repair. See image of mine below
I always missed the authorisation ID: xxxxxx part.
The NCF tool hangs at "finalising job phase2...please...wait". During this time the dreambox boots and show "hardware could not be found" on the tv screen.
I have tried NCF tool versions 2.5 and 3.0, I get the same result.
Now my point is why is NCF tool not getting the "authorisation ID" and what is "authorisation ID"?
I think the solution lies somewhere in there.
best regards and I truly, do appreciate your time and support.
NB: this problem (Hardware could not be verified) started when I mistakenly did an online software update.
I have observed that it is different from the message I get from the NCF tool when I do the repair. See image of mine below
I always missed the authorisation ID: xxxxxx part.
The NCF tool hangs at "finalising job phase2...please...wait". During this time the dreambox boots and show "hardware could not be found" on the tv screen.
I have tried NCF tool versions 2.5 and 3.0, I get the same result.
Now my point is why is NCF tool not getting the "authorisation ID" and what is "authorisation ID"?
I think the solution lies somewhere in there.
best regards and I truly, do appreciate your time and support.
NB: this problem (Hardware could not be verified) started when I mistakenly did an online software update.