0
hello mate
I have tried all the suggestions you gave me and I happen not to achieve any positive results.
1. I started by making sure my networking is working
I use a crossed RJ45 (UTP) cable to connect the 800se directly to my pc.
I connected a mini usb from the box to the pc as well.
Next, I configured my LAN adapter as shown in the photo below
I with box set up in 192.168.1.77 ***SERIAL SETUP
and to test the next network I pinged the box as shown below
to confirm my network configuration is working.
when I try to load ssl84d,84,82 with NCF 3.0 this is what results in photos, whichever one I try to load
using optiflasher to repair no ca found or load image files have proved futile.
this time, I have been trying to load the default allrussian image. and ssl82,84 or 84d.
in serial mode I telnet and this is the result
I have tried all the suggestions you gave me and I happen not to achieve any positive results.
1. I started by making sure my networking is working
I use a crossed RJ45 (UTP) cable to connect the 800se directly to my pc.
I connected a mini usb from the box to the pc as well.
Next, I configured my LAN adapter as shown in the photo below
I with box set up in 192.168.1.77 ***SERIAL SETUP
and to test the next network I pinged the box as shown below
to confirm my network configuration is working.
when I try to load ssl84d,84,82 with NCF 3.0 this is what results in photos, whichever one I try to load
using optiflasher to repair no ca found or load image files have proved futile.
this time, I have been trying to load the default allrussian image. and ssl82,84 or 84d.
in serial mode I telnet and this is the result