0
(04-12-2013, 03:40 PM)fairbird Wrote:
Sure, as I am newly registered forum user apologies for missing essential mandatory information.
Ok, following is the information.
1. dm800hd (i think it's not a se version since there is no color oled)
2. clone
3. sim 2.10
4. no ca found after flashing image (trying to replace old #76c with #84)
In addition, yesterday I tried to flash using NFC tool (dm connected with rs232 only) and noticed that this time "sending flash loader" took only few seconds to go to 47% but then the rest was slowly progressing until 100%. And that took 5/6 hours. Finally at the end of 100% there was no any message, on nfc tool, confirming anything. Just nothing.
Kind Regards,
To add latest on top of the rest.
This morning tried to use Sunray FlashUp (Sim4 500hd 800se 800 V1.3.3.7) with recover bad sectors.
What happened was that upload of the flasher took few seconds (very quick) , but then it stuck again on the message "upload complete,waiting for acknowledgment". And interestingly display on dm800 changed from "Dreambox" (which normally appears each time when power button pressed down before powering dm itself) to "no ca found error". Don't know maybe this Sunray tool Sim4 version makes difference, not sure.