01-24-2013, 09:21 PM
(This post was last modified: 01-24-2013, 09:33 PM by Soulmanfrankie.)
0
Ok. Well I followed those instructions and got the same result. After I tried 'Repair' and still got No CA found, I downloaded that image and tried to flash it. Optiflash did, at least, open another window, which instructed me to press the on/off button on the box and plug in the power, then wait for the 'Stop' message. I did that and waited. It didn't happen. Still got the same result. No CA found.
I tried again after going into Advance setting and toggling from the default 'Clone' setting to the 'Original' setting mode. Made no difference.
I'm ready to leap off a tall building.
Any ideas?
P.S. I also tried to flash in both 'Normal' and 'Advanced settings. Still got the same result.
I have teamviewer, if you think it would help.
I tried again after going into Advance setting and toggling from the default 'Clone' setting to the 'Original' setting mode. Made no difference.
I'm ready to leap off a tall building.
Any ideas?
P.S. I also tried to flash in both 'Normal' and 'Advanced settings. Still got the same result.
I have teamviewer, if you think it would help.