0
@fairbird... Yes, I tried your recomendations... only null modem cable is connected, Flash loader starts, but when it arrive at end of crossbar, in display show me ERROR1: NOT CA FOUND... and I cannot make anything with box... It's blocked...
Program tell me that I load a .nfi image, I select a Ferrri image .nfi, program accept this option, but program only show me busy during 5 or 6 seconds... and then option job! button is active again... because error messsage "ERROR1: NO CA FOUND" in display is show me..
This message is show me when crossbar is in progressing....
Power ON DB Device [ESC to Abort]
DM8000HD Detected !
Dreambox Detected...Ok!
Sending Flash Loader...
When crossbar arrives at 100% show me this message:
Power ON DB Device [ESC to Abort]
DM8000HD Detected !
Dreambox Detected...Ok!
Sending Flash Loader...
Second Stage OK!
Boot Success & Ready For Job Process!
and then program tell me that I can choose and image for load... I choose this one:
Name: Ferrari-SSL87F-Nemesis2.6-SVN110r0-dm8000-Snack.nfi
FSize: 60466624 bytes
but in display box already show me * ERROR1: NO CA FOUND * ... ok?... and at 4 or 5 seconds, program actives job command button again, no load image , not respond!.... and then in display show me:
Dream Multimedia
192.168.1.77
* SERIAL MODE *
but no load nothing....
I hope that you understand me...
Regards again
Paco
Program tell me that I load a .nfi image, I select a Ferrri image .nfi, program accept this option, but program only show me busy during 5 or 6 seconds... and then option job! button is active again... because error messsage "ERROR1: NO CA FOUND" in display is show me..
This message is show me when crossbar is in progressing....
Power ON DB Device [ESC to Abort]
DM8000HD Detected !
Dreambox Detected...Ok!
Sending Flash Loader...
When crossbar arrives at 100% show me this message:
Power ON DB Device [ESC to Abort]
DM8000HD Detected !
Dreambox Detected...Ok!
Sending Flash Loader...
Second Stage OK!
Boot Success & Ready For Job Process!
and then program tell me that I can choose and image for load... I choose this one:
Name: Ferrari-SSL87F-Nemesis2.6-SVN110r0-dm8000-Snack.nfi
FSize: 60466624 bytes
but in display box already show me * ERROR1: NO CA FOUND * ... ok?... and at 4 or 5 seconds, program actives job command button again, no load image , not respond!.... and then in display show me:
Dream Multimedia
192.168.1.77
* SERIAL MODE *
but no load nothing....
I hope that you understand me...
Regards again
Paco