11-21-2012, 06:17 AM
0
Thanks for the reply,
Beleive me! just try if you have a DM800se and NCF, the clone box boots without the sim, Yassinovs program is smart, it can trick the box to boot without the sim. I wish I had a way to show you. Hope that guru Yassinov confirms that the clone box can boot with NCF when no sim.
Sim reader is good as I can read atr off DM_sims for any other sim card. I know this for sure. Can read many type sims with this reader.
Sim does a tuner check, I found the following from my old (saved) and current dmesg commands. That is the CA check in the fol.
Old dmesg with good SIM
DVB: registering new adapter (BCM7405)
autodetecting NIMs...
ret: 2, feid: 13
Found: Slot A, ID: 13 (by CA)
Initializing adapter 0 (BCM4505-DVB-S2)
bcm4506: found 4505, revision 0(b0)
bcm4506: bcm_initAP
bcm4506: upload & start firmware
enable tsm0
bcm4506: bcm4506: ap not running - start now
bcm4506: uCode 0x5a
bcm4506: no bcm3445 detected
i2c_enable_adc failed! -145
DVB: registering adapter 0 frontend 0 (bcm4506)...
registered vtuner vtuner0, minor 58
Current dmesg with no bad SIM/ or booted with NCF
DVB: registering new adapter (BCM7405)
registered vtuner vtuner0, minor 59
registered vtuner vtuner1, minor 58
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe: write ret=-145
enable tsm0
Beleive me! just try if you have a DM800se and NCF, the clone box boots without the sim, Yassinovs program is smart, it can trick the box to boot without the sim. I wish I had a way to show you. Hope that guru Yassinov confirms that the clone box can boot with NCF when no sim.
Sim reader is good as I can read atr off DM_sims for any other sim card. I know this for sure. Can read many type sims with this reader.
Sim does a tuner check, I found the following from my old (saved) and current dmesg commands. That is the CA check in the fol.
Old dmesg with good SIM
DVB: registering new adapter (BCM7405)
autodetecting NIMs...
ret: 2, feid: 13
Found: Slot A, ID: 13 (by CA)
Initializing adapter 0 (BCM4505-DVB-S2)
bcm4506: found 4505, revision 0(b0)
bcm4506: bcm_initAP
bcm4506: upload & start firmware
enable tsm0
bcm4506: bcm4506: ap not running - start now
bcm4506: uCode 0x5a
bcm4506: no bcm3445 detected
i2c_enable_adc failed! -145
DVB: registering adapter 0 frontend 0 (bcm4506)...
registered vtuner vtuner0, minor 58
Current dmesg with no bad SIM/ or booted with NCF
DVB: registering new adapter (BCM7405)
registered vtuner vtuner0, minor 59
registered vtuner vtuner1, minor 58
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe_common: retrying i2c transfer
fe: write ret=-145
enable tsm0