11-15-2012, 02:03 PM
0
I am using optiflasher 2.0.0c and when I tried to use write bootloader with nul modem cable it was working because at the end massage was "success" meaning that cable is ok.But when I try to flash image after two and half hours the is no massage "success" only "Finalizing Job Phase2...Please Wait...
If I try to flash with lan cable I can not get box in "stop" mode to get IP. I know that IP was 192.168.2.99. All this was done with PC. I even tried with "DreamUP Patched" and without success.
When connect laptop with the same cable "lan" cable to router it works perfectly (internet)which means cable is ok.
I do not know whats wrong. I will try to use laptop and lan cable.
This box drives me crazy.
Anyway thank for your patience.
If I try to flash with lan cable I can not get box in "stop" mode to get IP. I know that IP was 192.168.2.99. All this was done with PC. I even tried with "DreamUP Patched" and without success.
When connect laptop with the same cable "lan" cable to router it works perfectly (internet)which means cable is ok.
I do not know whats wrong. I will try to use laptop and lan cable.
This box drives me crazy.
Anyway thank for your patience.