0
I had tried many combination to repair, LD1 & LD2 with Null Model Cable Only (advance mode 2)
I still get error "Wrong Boot Response", optiflash cannot connect or veryfied with the unit but Optiflasher can detect it is "DM800HD", is there any other ways to solve problem?
I saw another thread using Hyperterminal, please inform how to set, what is
- the baud rate: 9600 bps? or others
- how many databits, 7 or 8 bits?
- what is the parity, Even or Odd?
- what is the stop bit, 1 or 2?
- what is the flowcontrols? Hardware, Software or None?
I still get error "Wrong Boot Response", optiflash cannot connect or veryfied with the unit but Optiflasher can detect it is "DM800HD", is there any other ways to solve problem?
I saw another thread using Hyperterminal, please inform how to set, what is
- the baud rate: 9600 bps? or others
- how many databits, 7 or 8 bits?
- what is the parity, Even or Odd?
- what is the stop bit, 1 or 2?
- what is the flowcontrols? Hardware, Software or None?