06-12-2012, 04:29 PM
0
Hi all,
Have been trying to flash new DM800 HD and have had same problems as listed here. The standard repair options don't work when you have no means of rebooting/restarting the box.
With the no ca found, holding button down during power up no longer works.
Using optiflash ver1.8 can repair no ca found, but then what? can't reboot so power off/on back to no ca found. Display after repair shows either "**SERIAL MODE or SETUP**"
Flashing new image OpenPli2.1-beta-dm800-ssl84b etc optiflash works loads flash program then image. Phase 1 completed OK phase 2 "finalizing please wait" hangs at this point.
Other images tried same result.
Is optiflash ver1.8 the correct program or should I be doing someting else.
As always any help appreciated.
Thanks
Have been trying to flash new DM800 HD and have had same problems as listed here. The standard repair options don't work when you have no means of rebooting/restarting the box.
With the no ca found, holding button down during power up no longer works.
Using optiflash ver1.8 can repair no ca found, but then what? can't reboot so power off/on back to no ca found. Display after repair shows either "**SERIAL MODE or SETUP**"
Flashing new image OpenPli2.1-beta-dm800-ssl84b etc optiflash works loads flash program then image. Phase 1 completed OK phase 2 "finalizing please wait" hangs at this point.
Other images tried same result.
Is optiflash ver1.8 the correct program or should I be doing someting else.
As always any help appreciated.
Thanks