06-28-2017, 06:43 PM
0
Thanks again. I had tried everything before, but worth trying again. So here we go:
Dreambox connected with correct usb cable and cross over lan cable with PC port set to 192.168.1.10.
1) Run JapharFlasher (unpatched dreamups 1.3.3.9 or 12 does not recognize dreambox after sending flash loader, when things used to work all I had to do was switch off and then back on again to carry on) with recover bad sector selected.
2) Flash loader finishes and it tells me it is now in HTTP mode (well it is not as there are no LAN led on and a scan of ip address does not reveal any new address for the dreambox)
3) Press Flash and select SSL84 (doesn't matter what I select as it does not work anyway).
4) It hangs on "Calculating checksum".
Now with Optiflasher. Same hook up for dreambox as before.
1) Select the correct com port, select Advanced Mode 2 and select Repair[NO CA FOUND], pick DM500HD sim 2.10 SSL84
2) Press “Do Job” and switch on the box. Optiflasher progresses to “Boot success & ready for job process”
3) Command button returns to “Do job”. Switch off the box
4) Select Write image and switch on the box again
5) Click on Get My Image Socket and select Sim2.10
6) Swith on the box and get “error #11004”
I tried the same once more and this time I got Socket Error #11054. Note that the LAN remains dead as usual.
I have scrren dumps of the various stages above if they could be useful, but I do not know how to add the here.
I am stumped
Dreambox connected with correct usb cable and cross over lan cable with PC port set to 192.168.1.10.
1) Run JapharFlasher (unpatched dreamups 1.3.3.9 or 12 does not recognize dreambox after sending flash loader, when things used to work all I had to do was switch off and then back on again to carry on) with recover bad sector selected.
2) Flash loader finishes and it tells me it is now in HTTP mode (well it is not as there are no LAN led on and a scan of ip address does not reveal any new address for the dreambox)
3) Press Flash and select SSL84 (doesn't matter what I select as it does not work anyway).
4) It hangs on "Calculating checksum".
Now with Optiflasher. Same hook up for dreambox as before.
1) Select the correct com port, select Advanced Mode 2 and select Repair[NO CA FOUND], pick DM500HD sim 2.10 SSL84
2) Press “Do Job” and switch on the box. Optiflasher progresses to “Boot success & ready for job process”
3) Command button returns to “Do job”. Switch off the box
4) Select Write image and switch on the box again
5) Click on Get My Image Socket and select Sim2.10
6) Swith on the box and get “error #11004”
I tried the same once more and this time I got Socket Error #11054. Note that the LAN remains dead as usual.
I have scrren dumps of the various stages above if they could be useful, but I do not know how to add the here.
I am stumped