[Zainb]

0

Hello,

When i start the ncf.
There is a message: be sure that the cable is plugged in.
Then i click OK
but then i get an message: no rj45 connected and then the connection leds are turning on
So NCF is too fast. The Db needs time to connect.
How can i fix.
Im stuck on CA

Greets,

PS: sorry for bad english im dutch :)

[Zainb]

0

Sorry,

My details:
Dm800se clone
Sim 2.10
Ssl84b
NO CA after flash

[Zainb]

0

Hello,
I have a crossover cable.
But the DM Connects after that message.
Greets,

[Zainb]

0

Please post the log of error or screenshot from software

When is see this, the dreambox LAN lights light up

---

Now i have the same error with this code on the oled:
192.168.1.77
# serial setup

---

And now after DM800se Detected!
There says this:
Network ip range is valid processing...

---

And now i get an error:
Privileged instruction.

---

Another question.
By sim2 ssl BT
Is that the ssl what you want or what now is installed on de DB

---

And now the cannot proces authorization error.
Please check;
Network cable
Network domain

---

PS: if i use NCF 1.0 then it hangs on finalizing Job Phase2 please wait

[Zainb]

0

you have something wrong for sure !
Please go to command prompt on your windows (CMD) & write :
ipconfig
then write here your IPv4 adress + your Default Gateway

I have done that 3 times
It dont work

[Zainb]

0

Please go to command prompt on your windows (CMD) & write :
ipconfig
then write here your IPv4 adress + your Default Gateway i still wait your answer

No difference.