[estebanito]

0

Hi Yassinov,

I ve got a DM500hd close sim2.1 which does not boot at all for a week. I downloaded you NCF and Optiflasher (registered after donation) and tried to fixed it but to no avail.

After flashing it with a SSL loader and compatible image I only managed to go as far as getting the message ...
Link: Fail
... on my TV through the HDMI output during the boot sequence. When the box is powered on, it immediately goes into stand bye (red led on). I need to press on/off button for some time before it starts booting, but the green led keeps flashing not in a constant manner. It flashes a few times, then stops, then flashes again etc etc etc.

Tried so far to:
- remove sim card and repeat the while process
- flash through the web interface

Another issue is that the enternet port does not always work. I need to plug and unplug the cable several times before I get some kind of IP from my router.

Any suggestions are welcome.

Thanks.

[fairbird]

0

Do you have mini usb? if you have it try to flash SSl with mini usb only by optiflasher then unplugin box and see what happen if don't succeed try to flash image with mini usb....

[estebanito]

0

Do you have mini usb? if you have it try to flash SSl with mini usb only by optiflasher then unplugin box and see what happen if don't succeed try to flash image with mini usb....

I tried that. I flashed the SSL and then the image through the webif. No good.

I flashed the SSL. then the image and then again the ssl though the mini-usb only. No good.

[fairbird]

0

What exactly message error you got? And from what you got it? did you flashed wrong image or SSl?
Also did you check power adapter supply?

[estebanito]

0

What exactly message error you got? And from what you got it? did you flashed wrong image or SSl?
Also did you check power adapter supply?

i did check the power adapter supply. Replaced it with a similar one from my DM500. Same problem.

I am plugging the box to TV through HDMI, after flashing successfully SSL and patched image. It tries to bot, and i get for a very short time the mesage
Link : Fail on the TV screen and tries to reboot again. The same thing happen over and over again.

Seems like a hardware fault of some kind ...

[fairbird]

0

If the green led flashing repeatedly in this case perhaps hardware problem so must be take it to technical.
But before do this try to use normal wire connection from box to TV maybe HDMI make some problem for box "not sure just guess" then reflash box again first flash ssl and unplug box after this plug box and flash image and i recommend to you openpli or oozoon images..Hope help you.