01-27-2016, 07:51 PM
0
Hi Guys,
I have an original dm800se which will only work when I flash a new image (does not matter which image), but after I ref lash if I have to reboot or machine goes into standby it will not boot up. Only way to get it working again is to reflash.
Any ideas?
T
I have an original dm800se which will only work when I flash a new image (does not matter which image), but after I ref lash if I have to reboot or machine goes into standby it will not boot up. Only way to get it working again is to reflash.
Any ideas?
T