0
My clone box has been causing me some issues for a while now. I am unable load up an image to entirety, it fails on install about 1/3 way with an error of partition 3 corrupt or full.
I ran dreamup to repair the sectors and it did find a sector with a problem but the best I can do is upload and then it fails during flash install.
I tried to telnet but no OS to run telnet on box.
I am only able to connect to the box in http stop mode. Is there a rescue method to boot from USB or something else? This has nothing to do with second stage boot loader/no CA found. too much data (or bad sectors) in partition 3 (end: 04000000, pos: 04000000)
I ran dreamup to repair the sectors and it did find a sector with a problem but the best I can do is upload and then it fails during flash install.
I tried to telnet but no OS to run telnet on box.
I am only able to connect to the box in http stop mode. Is there a rescue method to boot from USB or something else? This has nothing to do with second stage boot loader/no CA found. too much data (or bad sectors) in partition 3 (end: 04000000, pos: 04000000)