[impuls]

0

-DM800HDse
-Clone
-SIM estar v3.0
- After flashing boots only with Dream multimedia on display

stop or recorvery mode does't work
with Dreamup i get uploading flashloader but hangs on
waiting for acknowledge not able to hit the flash button
force the flash button gives the message calculating checksum
while loading the right image.

who can help me to fix this problem?
thanks

[impuls]

0

Hi
You described your problem by using other software !
Have you used OptiFlasher Pro Ultimate or not ?
If yes which message or result you got ?

Yes i used optiflasher and after some struggling how the software works, i was able to flash the image using the serial connection but when it was on 100% it did get the message wrong architecture
but i'm sure i used the right image?

Thx

[impuls]

0

may you copy the image name from the file & write it here please .

this is the used image:

estar_OpenPLI 4.0-dm800se-OE2.nfi and also tried others like OpenPli_4.0-EstarV3sim-dm800se-by_intercepter(20160522).nfi
but none of them work?

[impuls]

0

Please try with OptiFlasher the following steps :
Click :
-Advanced
-Detect Port & Select it
-Select Loader : LD4 (Estar)
-Select Repair [NO CA FOUND]
-Chose ESTAR SIM
then start with : dm800se-estar-sim-ssl82 Do Job
after that apply with same steps with : dm800se-estar-sim-ssl84
at end Flash your Image based SSL84 .

the screen looks like this now, how long does it take to finalize job phase2?
Thanks

Power ON DB Device [ESC to Abort]
DM800HD SE Detected !
Dreambox Detected...Ok!
Sending Estar Flash Loader...
Second Stage OK!
Boot Success & Ready For Job Process!
Authorization id: BFE3E252
Flashing Bootloader Phase1...
Finalizing Job Phase2...Please Wait...

[impuls]

0

Possible reason maybe you have some bad flash sectors !
Try use "Sectors Recovery" option from Settings and try again .

If i use the bad sectors recovery option I need to fill in the IP adress
192.168.1.77 i don't know why because i don't use these kind of internal IP adress range and i do get a time out connection error

[impuls]

0

I created the right network IP range but still getting timeout network connection
but i am able to connect the webbrowser with IP 192.168.1.77
but can't flash the bootloader or image nothing is happening???

Still no luck please who can help??
Thx

[impuls]

0

As i told before with a extra router i created the correct IP range but still timeout error
and i am also able to connect with the box using the webbrowser but when i hit the flash
button nothing happens

[impuls]

0

Hi,

Thanks very much for your online help and the time you spent to fix my box
maybe you can inform me what is the flash chip so i can try to use my
heating gun maybe that will bring some luck.
Please let me know if you have some other ideas to takle this problem

Have a nice weekend,
best regards,
Arie

[impuls]

0

Thanks for the picture, please let me know if you come up with other ideas about
fixing the hardware problem.

Bye bye