The following warnings occurred: | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Warning [2] Undefined array key "isclosed" - Line: 203 - File: inc/plugins/guestwarn.php PHP 8.2.26 (Linux)
|
OptiFlasher doesn't work - Printable Version +- InfoServ (https://www.yassinov.com/forum) +-- Forum: Satellite Equipment (https://www.yassinov.com/forum/forumdisplay.php?fid=9) +--- Forum: Dreambox OptiFlasher Pro [Basic EDition] (https://www.yassinov.com/forum/forumdisplay.php?fid=35) +--- Thread: OptiFlasher doesn't work (/showthread.php?tid=2152) |
OptiFlasher doesn't work - Kalle08-15 - 11-05-2013 My box is a DM800SE SIM: A8P (works like it was a genuine box, but it is a clone) Display of the box shows: "no CA found" I wish WRITE IMAGE / Restore backup mode. Loader LD2 (genuine), COM4 used without LAN wire. Image: newnigma2-release-dm800se-v3.3.nfi Until step 8 works normally, like tutorial writing. Message: Power ON DB Device [ESC to Abort] DM800HD SE Detected ! Dreambox Detected...Ok! Sending Flash Loader... Second Stage OK! Boot Success & Ready For Job Process! Name: newnigma2-release-dm800se-v3.3.nfi FSize: 45622432 bytes And than nothing more. The "Do Job" button is black again. I only can start it new. Have somebody an idea? THX RE: OptiFlasher doesn't work - Kalle08-15 - 11-05-2013 (11-05-2013, 01:16 AM)YASSINOV Wrote: You are not allowed to view links. Register or Login to view.For DM800se & DM500hd you cannot process Flash operation using the USB to Uart Port only , Lan RJ45 + Mini usb cable is necessary Okay, I tried it several times with both cables. LAN and USB/miniUSB It happends the same. Diverse settings, LD1-LD2, normal and advanced mode. Always : "no CA found" on the black display.... The job "Repair [no CA found]" also doesn't work, probably because I don't know what kind of SIM should I chose from the list. It is an A8P SIM, not a 2.10 or 2.01 (11-05-2013, 07:39 PM)Kalle08-15 Wrote: You are not allowed to view links. Register or Login to view.When I try to repair "No ca found" after "Do job" comes a window: "Enter IP shown ON ***STOP-MODE***(11-05-2013, 01:16 AM)YASSINOV Wrote: You are not allowed to view links. Register or Login to view.For DM800se & DM500hd you cannot process Flash operation using the USB to Uart Port only , Lan RJ45 + Mini usb cable is necessary And There is no IP, only "Err1: no CA found" What should I write in? |