Flashing Image gets to 100%, then phase 2 just stops working - encblue - 06-13-2013
I've been basically trying to un brick my dm800 clone sim 2.10 by every means possible (without success).
Last throw of the dice was to try Opti Flashwer, i get through flashing image phase 1 ok (go's to 100%), when it go's to phase 2, nothing happens, it just seems to stop responding :-(
I've left it for more than 2 hours on phase 2 with no response...
Any suggestions?
RE: Flashing Image gets to 100%, then phase 2 just stops working - fairbird - 06-13-2013
1-open box
2-remove sim carefully
3-replace it again and make sure in correct place
4-use optiflasher and follow (3-Fix Bad Sector "Sectors Recovery")
[Only registered and activated users can see links You are not allowed to view links. Register or Login to view.]
RE: Flashing Image gets to 100%, then phase 2 just stops working - fairbird - 08-01-2013
Closed Not Followed ...
|